Hotline
+86 512-8166609689,Fabrication of stainless steel pipe bends for storage tanks - Doer equipment
Classification:Forum PublishTime:2019-09-26 15:24:56
Fabrication of stainless steel pipe bends for storage tanks
The fabrication of stainless steel pipe elbow of storage tank consists of the following points:
1. Stainless steel pipes must be seamless and must be purchased from large manufacturers.
2. Degrease the inner side of the stainless steel pipe (acetone + clean rag) before bending, and the butt weld must be subject to 100% radiographic inspection.
3. The elbow must be bent with the elbow mould, and the pipe diameter area after the elbow is formed shall not be less than 90% of the original pipe diameter area. The two ends behind the bend are sealed with self-adhesive tape to prevent the entry of stolen goods.
4. When bending, leave 100mm allowance at the end (extending out of the barrel).
Prev: 88,Quality process control and inspection method of storage tank equipment - Doer equipment
Next: 91,How to fill the storage tank with pearlite - Doer equipment
News
- 216、Advantages of Double Metal Full Capacity Tank … [2023-05-09]
- 215、Design principles for low-temperature storage … [2023-05-09]
- 214、Low temperature storage tank safety education … [2023-05-09]
- 213、Objectives of project construction management-… [2023-05-09]
- 212、Quality service advantages of Doer large low-t… [2023-05-09]
- 211、Advantages of Doer Large Low Temperature Stora… [2023-05-09]
- 216、Design scope of atmospheric and low-temperatur… [2023-05-08]
- 215、Process flow of low-temperature LNG storage ta… [2023-05-08]
- 214、Testing methods for low-temperature argon stor… [2023-05-08]
- 213、Performance Description of Low Temperature Eth… [2023-05-08]